Revo Micro plays nice with Bowden and direct drive setups, but its lightweight construction makes it an ideal choice for Bowden setups. With an anodized black heatsink, not only does Revo Micro run cool – it looks cool, too.įlexible to any setup. Unlike other solutions on the market, a positive temperature coefficient (PTC) means the Revo HeaterCore can not melt at extreme temperatures: power reduces as it gets hotter, so hazards are reduced in the event of a thermal runaway. Are you looking to buy a E3D Revo for the Prusa Mini in Australia Revo Prusa Mini Edition is a drop-in replacement for your Prusa Mini & Mini+. Revo Nozzles are a factory sealed nozzle and heatbreak in one, so they’re easy to fit and can’t leak material when in use. Change nozzles at room temperature using just your fingers. Prusa Mini+ upgrade featuring the E3D RapidChange Revo Micro No rmware changes are required to complete the upgrade. Please note, your printer may vary from the. The special manufacturing process gives this aluminum HotEnd the strength and low thermal conductivity of titanium, without actually being titanium. This is a complete upgrade guide suitable for an original Prusa MINI+ and Revo Micro or Revo Prusa Mini Edition. *For the Prusa Mini the 24v system is required
0 Comments
Leave a Reply. |